PCL
2-69
ESC
*b#M
0
Uncoded (Default)
1
Run-Length Encoded
2
Tagged Image File Format (TIFF)
byte
3
Delta Row
5
Adaptive Compression
9
Replacement Delta Row
999
Zlib
1002
Group 4
1003
Group 3 one dimensional
1004
Group 3 two dimensional K=2
1005
Group 3 two dimensional K=4
1006
TIFF word (16 bit)
1007
TIFF double-word (32 bit)
1008
Adaptive compression (includes TIFF
word and TIFF double-word)
Set Raster Compression Mode
Identifies the compression mode the host uses to transfer RIG data.
For instance, this command can be run-length encoding or TIFF
encoding.
Note:
For further information, see “Raster Compression Mode” on
page 2-79 and “Group 3 and Group 4 Raster Compression” on
page 2-84.
ESC
*b#W[data]
# = Number of Data Bytes
Transfer Raster Data by Row/Block
Transfers RIG data.
Note:
After each command, the cursor position is moved to the
beginning of the next raster row.
ESC
*rB
End Raster Graphics (Version B)
Signals the end of the raster graphics transfer. If a Raster Height is
specified, the cursor is moved to the first raster row past the Raster
Height.
ESC
*rC
End Raster Graphics (Version C)
Same as Version B, but:
• Resets the compression mode to uncoded.
• Sets the left graphics margin to 0.
ESC
*t#H
Raster Width (Destination)
Sets the width of the destination raster.
Table 2-27: Raster Graphics (Continued)
Command / Parameters
Function / Result
