Use
To
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the US factory default setting. You can increase
the width in 0.01
‑
inch increments.
•
216 mm is the international factory default setting. You can
increase the width in 1
‑
mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the US factory default setting. You can increase the
height in 0.01
‑
inch increments.
•
356 mm is the international factory default setting. You can
increase the height in 1
‑
mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
Reports Menu
Reports menu
Use
To
Menu Settings Page
Print a report on the current printer menu settings. The report also contains
information about the status of the supplies and a list of hardware options
that are successfully installed.
Device Statistics
Print a report containing printer statistics, such as supply information and
number of printed pages.
Network Setup Page
Print a report containing information about the network settings of the
printer.
Note:
This menu item appears only in network printers or printers
connected to print servers.
Understanding the printer menus
156
