Replace last scanned page and jammed originals if restarting job.
Try one or more of the following:
•
Touch
Cancel job
to clear the message and cancel the scan job.
•
Touch
Scan from automatic feeder
to continue scanning from the ADF immediately after the last
successful scan job.
•
Touch
Scan from flatbed
to continue scanning from the scanner immediately after the last successful
scan job.
•
Touch
Finish job without further scanning
to end the last successful scan job.
•
Touch
Restart job
to restart the scan job with the same settings from the previous scan job.
Replace maintenance kit, recommended life exceeded [80.xy]
The printer is scheduled for maintenance. For more information, go to
contact your service representative.
Replace maintenance kit to resume printing [80.xy]
The printer is scheduled for maintenance. For more information, go to
contact your service representative.
Replace missing cartridge [31.xy]
Install the missing cartridge to clear the message. For more information, see
“Replacing the toner cartridge”
.
Replace missing fuser [80.xx]
1
Install the missing fuser. For more information, see the instruction sheet that came with the replacement
part.
2
From the control panel, touch
Supply replaced
to clear the message.
Replace missing imaging unit [31.xy]
Install the missing imaging unit. For more information, see the instruction sheet that came with the supply.
Replace roller kit [81.xx]
Try one or more of the following:
•
Replace the roller kit. For more information, see the instruction sheet that came with the part.
•
From the printer control panel, select
Continue
to clear the message and continue printing.
Troubleshooting
278
