iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
83
Table 3.3.5.2-3 CO/IP ATTRIBUTES III (PGM 143)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
DEFAULT
14
01-02 INT ACCESS CODE
….
When an incoming call includes the international
Country code in the ISDN call SETUP message, the
Country code will be included in the station display.
To include the Country code, Incoming Prefix insertion
(button 12 above) and CLI Display for the station (PGM
114-button 1) must be On.
15
01-02 AREA CODE
……
Regional ISDN providers may use the Local Prefix and
Area codes for special services. The system will insert
this Local Area Code in the call SETUP messages
defined under button 13 above.
-
16
01-02 PREFIX CODE
….
Regional ISDN providers may use the Local Prefix and
Area codes for special services. The system will insert
this Local Prefix Code in the call SETUP messages
defined under button 13 above.
-
17
01-02 CLI TRANSIT
(1:ORI/0:CFW):CFW
When the system must send CLI to the ISDN for an off-
net call, the CLI can be either the original ca
ller’s CLI or
the CLI of the Off-net forwarding/transferring station.
CFW
18
01-02 PRESERVE NAME
(1:ON/0:OFF): OFF
For DID lines, the CLI is normally displayed only during
ringing. If enabled here, the CLI will be displayed for the
entire call duration.
OFF
19
01-02 REDIRECT INFO
NO SERVICE (0)
When the system needs to send Redirecting number to
the ISDN for an off-net call, the Redirecting number can
be either the original caller’s CLI or the CLI of the Off-
net forwarding/transferring station.
If it is no service then system will not send this
information.
If it is OGR CLI (original CLI) then system will send
original CLI that is received from incoming CO line.
If it is CFW CLI then system will send redirecting CLI
that is CLI for call off-net call forwarded station.
NO
SERVICE
20
01-02 INC CLI CHOICE
(1:ORI/0:TRANSIT):TRS
Incoming CLI Choice
– When ISDN setup message
have two CLI (Transit Point CLI / Original CLI), by using
this option, CLI can be chosen.
Transit
21
01-02 CALLING NUM PLAN
(0-6):ISDN/TELEPHONY (1)
ISDN Calling Party Numbering Plan can be
programmable.
0: Unknown.
1: ISDN / Telephony.
2: Data / Numbering.
3: Telex.
4: National Standard.
5: Private.
6: Reserved.
ISDN/
Telephony