iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
151
Table 3.3.7.2-1 STATION GROUP
— CIRCULAR & TERMINAL GROUPS (PGM 191)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
4
CIRC 401 ANNC2 LOC
VSF ANNC .. (01
– 70)
The Station Hunt Group can be assigned a
2nd announcement, which is played if the call
remains queued beyond the ANNC 2 TMR
duration. The announcement location is the
VSF ANNC2 number. An entry of 00
indicates no announcement. Including ‘#’ at
the end of an entry instructs the system to
disconnect after the announcement.
01~70
00: none
5
CIRC 401 ANNC2 RPT TMR
(000 - 999) : 000.
The 2nd announcement can be repeated to
calls that remain in queue at intervals of the
Announcement 2 RepeatTimer.
NOTE)
Repeating must be “ON” under button
6 below.
000~999
seconds
000
6
CIRC 401 ANNC 2 RPT
(1: ON / 0: OFF): OFF
After the 2nd announcement, if the call
remains queued to the group, the 2nd VSF
announcement can be repeated at the
AnnouncementRepeatTimer interval.
0: OFF
1: ON
OFF
7
CIRC 401 OVERFLOW DEST
S/H/V/SPD (Dial 1-4)
A call to the group will continue to route
through the group until answered or all group
members have been tried. The call will
remain at the last station or will pass to the
assigned OverflowDestination.1:Station,
2:Station group, 3:VSF Announce, 4:System
speed
Refer to
description
8
CIRC 401 OVERFLOW TMR
(000 - 600) : 180
A call to a group will remain at the last station
in the group or can be sent to the assigned
OverflowDestination after expiration of the
OVERFLOW Timer.
000~600
seconds
180
9
CIRC 401 WRAP-UP TMR
(000 - 999) : 002
After terminating any call, a Group member
will be maintained in a busy state for the
duration of the WRAP-UP Timer.
000~999
seconds
002
10
CIRC 401 NO ANS TMR(1s)
(00
– 99) : 15
Calls to a station in the group are directed to
the station, if unavailable or unanswered in
the NO AnswerTimer, the call can be routed
based on the assigned hunt process.
00~99
seconds
15
11
CIRC 401 PILOT HUNT
(1 : ON/ 0: OFF) : ON
A circular/terminal hunt group can be set so
that only calls to the pilot number (Station
Group number) will hunt.
0: OFF
1: ON
ON
12
CIRC 401 RPT NO MEMBER
(1 : ON/ 0: OFF) : OFF
If a call is received and no members are on-
duty, an ICM call will return re-order tone,
while a CO/IP call will be routed to the
overflow destination.
0: OFF
1: ON
OFF