iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
165
Table 3.3.7.2-7 STATION GROUP ATTRIBUTES
— UMS GROUP (PGM 191)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
10
UMS 410 PILOT HUNT
(1 : ON/ 0: OFF) : ON
A FS VM group can be set so that only calls
to the pilot number (station group number)
will hunt.
0: OFF
1: ON
ON
11
UMS 410 ALTER DEST
STA/HUNT
When a call comes into the group and there
are no group members available, the call
will be routed to the assigned
AlternateDestination.
Station or
Group
Number
....
12
UMS 410 HUNT TYPE
(1 : CIRC/ 0 : TERM): CIR
When a call is offered to the group, the
Hunt process can be defined for Circular or
Terminal hunt group.
0: TERM
1: CIR
CIR
13
UMS 410 WRAP-UP TMR
(002
– 999) : 002
After terminating any call, the VM port will
be maintained in a busy state for the
duration of the WRAP-UP Timer.
002~999
seconds
002
14
FORCED FWD DEST USAGE
(1:ON/0:OFF): OFF
Enables the system to redirect group calls
to the Forced destination defined under
button 15 below.
0: OFF
1: ON
OFF
15
UMS 410 FORCED DEST
S/H/V/SPD (DIAL 1-4)
When a call is delivered to the group the
system can redirect the call to the Forced
destination if enabled under button 14
above.
1:Station, 2:Station group
3:VSFAnnounce, 4:System speed
Refer to
description
-
16
GROUP NAME
……………………………….
A hunt group name can be designated.
20
character
….
Table 3.3.7.2-8 STATION GROUP ATTRIBUTES
— UCS SERVER GROUP (PGM 191)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
UCS SVR [411] ASSIGNED
UC Server 1 (01
–16)
UCS Server number, this value must be set
to 1.
01-16
1
3.3.7.3
Pick Up Group Assignment
– PGM 192
Under Pick-Up Group Assignments members are assigned to the Station Pick Up Group.
PROCEDURE
PICKUP GRP ASSIGN
ENTER GRP NUM(00-49)
Press the
[PGM]
button and dial 192 and enter group number (Ex. 00).
(eMG80/100:00~49/ eMG800:0~199)