iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
240
4.4
Web Admin Programming
4.4.1
System ID & Numbering Plans
Selecting the System ID & Numbering Plans expands the Navigation frame to display the available Program
groups as shown in the below figure.
Figure 4.4.1-1 System ID & Numbering Plans sub-menu
4.4.1.1
System ID
– PGM 100
Selecting System ID will display the following Input Entry page. Click
[Reset System]
to restart the system
after changing Nation code, Site name, Site detail, My area code, Multi area code, Numbering Plan, etc.
Figure 4.4.1.1-1 System ID
Under System ID, the country is identified using the international dial codes (Nation Code). A twenty-four (24)
character Site Name, Site detail and the local My Area Code maybe defined. This information is used to set
gain, frequencies and other system characteristics specific to the country and regional regulatory
requirements. The Site Name is primarily useful for the installer/programmer as a reference to customer.
Note)
In case of eMG, to change Nation code, Dip-switch 1 pole # 2 is ON; you cannot change the Nation
code while the switch is OFF.
In case of UCP, t
o change the Nation Code, the UCP Module “Mode” dipswitch pole 4 must be ON;
you cannot change the Nation code while the switch is OFF.
The rest attributes are additional options for Customer
’s convenience.
In case of UCP, the built-in VoIP DSP channels (VOIU) can be disabled allowing use of the DSPs for
the Multi-party Conference function.
In case of UCP100, SLIU channels cab be disabled or enabled.
