iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
313
4.4.3.3
Board Base Attributes - PGM 132
Selecting Board Base Attributes will display the Board Base Attributes data input pag.
Enter the Sequence number (refer to ‘Device IP Plan’ if you want to find the sequence number) and click
[Load]
to enter attribute values.
Use the check boxes to indicate which attributes to modify; data for checked attributes is stored for the entire
range of devices when saved. Click
[Save]
button after changing Value.
Enter Device/GW slot sequence number: eMG80/100: 1-300 / eMG800: 1-2890 / UCP:1-3688
Figure 4.4.3.3-1 Board Base Attributes
Appliances (Devices and IP Phones) can be connected to the iPECS over a managed WAN without the need
to employ a VoIP channel.
In this case, the system does not implement security (IPSec) or QoS treatment over the link. To implement the
managed WAN connectivity, the iPECS must be assigned with the IP address of the router for all appliances
that may attempt a point-to-point connection over the managed WAN, including devices on the iPECS LAN.
Note that if the device‘s Router IP address is not defined, the system will use the Router IP address defined in
System & Device IP Address Plan.
The default codec employed by each device can be specifically defined as G.711, G.729, G.723, G.722, or the
system default codec assigned.
Appliances include support for SRTP (Secure Real-Time Protocol), which employs Advanced Encryption
Standard (AES) to secure RTP packets. If RTP security is enabled then IPSEC or SRTP is implemented for
RTP packet.
