iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
345
Table 4.4.5.1-1 SYSTEM ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
G.722
Packetization
The G.722 voice frame packetization time determines the
interval at which voice samples are packetized and sent when
the G.722 codec is used.
10/20/30
(1 msec)
020
Transit-out
security
The system will check the IP address for transit-out calls in the
master system. If not valid the transit-out call is denied.
Unused/
Use
Use
Emergency call
attendantNotify
The Attendant can be notified when another user in the system
dials emergency number.
Unused/
Use
Use
3-Way
Conference
Preference
When 3-way conference calling, the system uses the selected
de
vice to establish the conference mixing. When “Local” is
assigned, the device, such as a SIP phone, must provide the
mixing. This option is available only for UCP.
Local/
MCIM
Local
First digit * in
SPD
Normally, when “*” is the first digit in a Speed Dial number, the
Display Security feature is activated so that the number is not
shown in the LCD of iPECS IP or LDP Phones. Otherwise, the
“*” is sent as the first digit to the carrier.
Display Security, Digit *
Refer to
description
Display
Security
Use Strong
Password
When enabled, passwords in PGM 162 must be longer than 10
digits and include both numbers and characters.
OFF
ON
ON
Station password
minimum length
If strong password is ON, then "minimum station password
length" is used.
If input station password length is less than "minimum station
password length", then it is not saved.
01~12
6
VSF SMTP port SMTP port used for the VSF and UVM gateway (VMIU/VMIB).
00001~
65535
25
CTI IP
When assigned, the system will accept 3rd party TAPI
messages only from assigned IP address.
0.0.0.0
Intercom busy
service
When busy, an intercom call may use Off-hook Voice-Over,
intrusion, or multi barge in room to connect to the called
intercom party.
Voice-over, Intrusion, Barge in (Monitoring), Barge
in(Conference)
Refer to
description
Voice over
Auto save new
message
After listening to a voice message, if the user takes no action,
the system can automatically save the message or leave the
message in the new message category.
Unused/
Use
Unused
IGMP query
usage
The system employs multi-cast packets for registration and
certain general functions such as MOH. With some multicast
snoop enabled Layer 2 switches, multicast packets are not
forward unless an IGMP query device exists in the network. This
entry enables the IGMP query option and system sends periodic
IGMP query message to avoid multicast blocking.
OFF
ON
OFF
IGMP query
interval timer
This timer defines the interval for each IGMP query message.
0~3600
(Sec.)
180