iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
Issue 2.3
557
4.4.13.6 Zone Attribute
– PGM 439
Selecting the Zone Attributes returns the Zone Attributes data input page. Enter the desired Zone number
range and click
[Load]
to assign Zone characteristics.Use the check mark to indicate which attributes to
modify; data for checked attributes is stored by clicking
[Save]
button.
Figure 4.4.13.6-1 Zone Attributes
The nation code, codec and VMIU/VMIB assigned for a Zone will be employed by all devices in the Zone
unless a different entry is made in Device Zone data. If the Device Zone data is default or assigned by the
MPB, the Zone data will take precedence.
The Zone Attributes define when and which VoIP channels to use for RTP packet relay. Local VoIP channels
are assigned to perform the packet relay function and the use can be defined as “if needed” or use the
assigned RTP Relay Group. For “if Need”, the MPB will employ the IP KTS STUN protocol to determine when
packet relay is required. If assigned “RTP Relay Group”, packet relay will always be employed for RTP packet
receipt.
Table 4.4.13.6-1 ZONE ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Nation Code
Nation code of devices in the zone. Available selections are
given in Country code table.
Country code
E.164 Management Information
(Outgoing Dial Number : E164-> Normal) (Incoming CLI Number: Normal ->164)
Area Code
Assign area code that is use to convert CLI format (normal
<-> E.164)
Max 5 Digits
International Access
Code
Assign international access code that is use to convert CLI
format (normal <-> E.164)
Max 5 Digits