Wireless SOHO
Installation and Operation Manual
16
2.5.3 Wireless DECT Handset Description
Figure 2.5.3-1 GDC-450H Component Description
2.6 Hardware Initialization
2.6.1 LWS-BS and LWS-WK
Once the LWS-BS and the LWS-WK have been properly installed in the desired locations, perform the
following:
1. Plug in the AC/DC adapter to the LWS-BS or the LWS-WK (use only the included AC/DC adapter,
SA-B122).
2. The LWS-BS or the LWS-WK is powered up and its display on the LCD will be activated.
3. Register the LWS-WK to the LWS-BS, see section 2.11
Note: The LWS-BS requires one minute to become fully functional after power on.
2.6.2 Wireless Handset
To start up the Handset:
1. Press and hold [ ] for approximately 2 seconds.
2. The handset automatically enters standby mode when a signal is located.
3. The handset automatically returns to standby mode whenever it is placed on the charger.
4. Register the Wireless handset to the LWS-BS, see section 2.11
To power-down the Handset:
1. Press and hold [ ] for approximately 3 seconds.