Wireless SOHO
Installation and Operation Manual
25
2.11.1.3 Registering LWS-WK to the LWS-BS
To register to the LWS-BS, below procedure is performed on the LWS-WK.
1. Press the
[Menu]
button to display the menu.
2. Highlight
[Phone Register]
using the Navigation up/down key, and then press the
[OK]
soft button
or Navigation
„OK‟ key.
3. Select
[Subscription]
using the Navigation up/down key, and then press the
[OK]
soft button or
Navigation
„OK‟ key.
4. Display
[Searching..1]
.
5. The system
[RFPI]
(e.g. 01234567890123) will display when a system is found.
6. The RFPI of your system is available from your System Administrator, or perhaps the attendant.
7. Press the
[OK]
soft button or
„Navigation „OK‟ key. In a few seconds, a confirmation tone is
received at the LWS-WK.
8. If the registration fails, repeat procedure from Step 1 to 7 at the LWS-BS and Step 1 to 7 from the
LWS-WK.
2.11.2 Terminating a Registration
To terminate a subscription, below procedure should be performed on the LWS-BS;
1. Press the
[Menu]
button.
2. Press
[Digit 1]
(CONFIGURATION submenu), or select
[1. CONFIGURATION]
using the
Navigation up/down key and
[OK]
Button.
3. Press
[Digit 4]
(STATION REGISTRATION sub menu), or select
[4. STATION REGISTRATION]
using Navigation up/down key and
[OK]
Button.
4. Press
[Digit 2]
(DEREGISTER STATION submenu), or select
[2. DEREGISTER STATION]
using
Navigation up/down key and
[OK]
Button.
5. Select the phone number using Navigation left/right key (S101~S107).
6. Press the Navigation
[OK]
button or
[OK]
soft key.
7. When the subscription is terminated, the below message is shown on LWS-BS LCD.
STATION : 10X
UNSUBSCRIBED : SUCCESS
DEREGISTER
: To erase registration information of both LWS-BS and Wireless terminals (LWS-
WK and GDC-450H handsets).
FORCED ERASE
: To erase registration information of the relevant Wireless terminal. (e.g. in
case that the terminal is missing or non-functional)).
In this case, the
registration information will be kept in the terminal itself.
All Data ERASE
: To erase registration information of all wireless terminals.
In this case, the
registration information will be kept in the terminals themselves.
Procedure for erasing the registration information in the terminal itself:
1. Press the
[Menu
] button.
2. Select
[Phone Register]
and press the
[OK]
button.
3. Select
[Reset]
on the Menu and press the
[OK]
button.
4. Enter the HS PIN Code [default:
0000
] using dial button. And then press the
[OK]
button.
5. Select
[Handset]
on the menu and the
[OK]
button.
Note:
