Appendix 1. System definitions
APP1 - 5
3) Communications Parameters
These high speed link parameters are used to set the opposite station for data communications, data
and communications cycle when communicating a defined data repeatedly through communication
modules.
(For detailed descriptions, refer to the User’s Manual relating to data communications)
(1) Network type : Used to set the type of the communications module
(2) Slot No. : Location number of slot where the communications module has been mounted.
(3) Local No. : Local number of the module which executes high speed link communications.
(1) Station type : Type of the communications module in the opposite station. Local or remote will be set.
(2) Station No. : Used to indicate the station that has invoked data during communications.
(3) Mode : Used to set the communications mode to Send or Receive.
(4) Block No. : Designating number for identification of a data block in the same communications
module.
(5) Data communications cycle : Used to set the cycle of sending and receiving of data.
(6) Area: I, Q and M areas should be set by the decimal number or word.
(7) Size : Number of words that will be sent and received.
