ARIA SOHO Version 1 Issue 0.3
ADMIN Programming Manual
June, 2006
54
PGM 181
DESCRIPTION
PROCEDURE
COMMENTS
Pause Timer
Used for Speed Dial or LNR; the
LDK System sends the dialed
digits to the outgoing CO line,
after the designated time.
+ Seconds (1
digits, Range=1-9) +
[HOLD/SAVE]
Preset Call Forward
Timer
After the timer expires, incoming
calls will be forwarded to a
predetermined Station.
+ Seconds (2
digits, Range=00-99) +
[HOLD/SAVE]
SLT DTMF Release
Timer
+ Seconds (2
digits, Range=01-20) +
[HOLD/SAVE]
3Soft Auto Release
Timer
3soft Button DKTU
(LDH-30DH Only)
In the 3soft button menu, if no
digits are pressed within the
designated time, the DKTU will
return to an idle state.
+ Seconds (2
digits, Range=01-30) +
[HOLD/SAVE]
VM Pause Timer
+ VALUE (100
m sec, 2 digits,
Range=01-99) +
[HOLD/SAVE]
Transit Connect Timer
Designates the amount of time
before the Master System sends
a connect message to the Slave
System when using a pulse
analog trunk.
+ VALUE (2
digits, Range=01-30) +
[HOLD/SAVE]
VMIB Message Rewind
Timer
Designates the amount of time
the System will wait for the
Station User to press the
[REWIND] button while listening
to VMIB messages.
+ VALUE (2
digits, Range=01-99) +
[HOLD/SAVE]
LCD Connect Timer
If this timer expires after starting
an outgoing call, the System will
regard that Line as connected; if
any digits are dialed after the
timer expires, the Pause is
automatically added before the
first added digit (CIS Only),
+ Seconds (2
digits, Range=01-20) +
[HOLD/SAVE]
LCO CPT Detect Timer
To check LCO status after LCO
is connected, the System
assigns CPT periodically with
this timer. To activate, CO-CO
Transfer CPT Detect should be
set to ON.
+ Seconds (2
digits, Range=01-20) +
[HOLD/SAVE]
