ARIA SOHO Version 1
Issue 0.2
Feature Description and Operation Manual
June, 2006
Ex. 3 Password for specific dial number—The International access code is 001, System
Administrator allows International calls by only those Users who know the System password.
ADMIN 220
ADMIN 221 (LDT)
ADMIN 222 (DMT)
LCR Mode
M12, M13
(Loop LCR enabled)
Bin 000
LCR Type: COL
LCR Code: 001
DMT: 00 00 00
Check Password: ON
Bin 00
CO Group: 01
Condition
There are 6 LCR modes. The mode is determined by Admin 220 – FLEX1:
- LCR Access Mode 00 (M00) – LCR call is disabled.
- LCR Access Mode 01 (M01) – Only Loop LCR is activated.
- LCR Access Mode 02 (M02) – Internal LCR and Loop LCR are activated.
- LCR Access Mode 11 (M11) – Loop LCR and CO LCR are activated.
- LCR Access Mode 12 (M12) – All types of LCR are activated; when dialing 9 or pressing
the Loop key, the System will wait for the next digits to compare to the LCR Table before securing a
CO Line.
- LCR Access Mode 13 (M13) – All types of LCR are activated when dialing 9 0r pressing the Loop
key, the System will secure the first available CO Line and wait for the next digits to compare to the
LCR Table.
The leading digits can be duplicated. FLEX2 and the DMT index make each entry unique.
The Leading Digit Table is sorted by leading digits, FLEX2 in LDT (INT, COL, BOTH) and DMT
index.
Internal LCR is applied if the dialed digits are matched with one of the leading digits and FLEX2
is INT or BOTH.
Loop LCR is applied if the dialed digits are matched with one of the leading digits and FLEX2 is
COL or BOTH.
Direct CO LCR is applied if the dialed digits are matched with one of the leading digits, FLEX2
is COL or BOTH, and the secured CO Line belongs to the programmed CO Group in DMT.
To work Loop LCR and Direct CO LCR differently with the same leading digits, there should be
a leading digit entry for loop LCR prior to the leading digits for direct CO LCR. It is possible if
the DMT index for loop LCR is smaller than the DMT index for direct CO LCR.
While Direct CO LCR is applied to ISDN CO, an ISDN information message with called party IE,
which includes only the numbering plan and numbering type, is sent to the Network when a
User dials a digit. It is for the network not to disconnect the line.
For Direct CO LCR, leading digits should be programmed in consideration with the dial tone
item provided by the Network.
Direct CO LCR does not use an alternative DMT index if a CO Line is already accessed.
LCR always has the higher precedence than the Flexible Numbering Plan Table.
LCR can be applied in the following instances:
- Dialing after accessing a CO Line by dialing a CO Line access code (9 or 0) only.
- Dialing after accessing a CO Line by pressing he {LOOP} button.
- Dialing without accessing a CO Line.
- Speed Dial
- Off-Net Call Forward
- Redial (if the previous call is LCR applied)
16
