ARIA SOHO Version 1
Issue 0.2
Feature Description and Operation Manual
June, 2006
2.5.2 Authorization Code
Description
If a Station is programmed for Authorization Code use, the User must enter the Authorization Code before
accessing a CO Line. An Authorization Code can be used for SMDR (DISA Account Code).
NOTE—Personal Authorization Codes should be kept secure by the System Attendant and individual
Station User to avoid unapproved phone calls being made).
An Authorization Code is assigned as 3-11 digits as applicable; each Station has a different Authorization Code.
Operation
To access a CO Line using an Authorization Code, perform the following Steps:
1.
When attempting CO Line access, a DND warning tone will be heard.
2.
Enter the Authorization Code, and press the # key (if authorization code is longer than 5 digits,
the # key is not needed).
3.
If valid, the CO Line will be connected; if not valid, an error tone will be presented.
To register an Authorization Code on a Station, perform the following:
1.
Press the [TRANS/PGM] button.
2.
Dial 31 (Authorization Code feature).
3.
Enter the desired Authorization Code and press the # key (if Authorization Code is longer
than 5 digits, the # key is not needed).
4.
Press the [HOLD/SAVE] button to accept changes.
To change the Authorization Code at a Station, perform the following:
1.
Press the [TRANS/PGM] button.
2.
Dial 32 and enter the current Authorization Code.
3.
Enter the new Authorization Code.
4.
Press the [HOLD/SAVE] button to accept the change.
Condition
Up to 200 Authorization Codes can be programmed on the System
Duplicate Authorization Codes can not be assigned to more than one Station.
If Loop LCR ACNT is set on a Station, the Authorization Code is required when the Station dials
the Loop LCR CO Access code (refer to Ref. A).
Reference
A.
LCR: 2.2.7
75
