ARIA SOHO Hardware Description and Installation Manual
Issue 1
STARTING THE ARIA SOHO
Aug, 2006
54
6.2.2 Entering the Programming Mode
To enter programming mode, perform the following Steps:
1. Lift the Handset.
OR
2. 1. Press the
[MON]
button on the Admin Station; the ICM tone should be heard.
3. Press the
[TRANS/PGM]
button and dial
* #
; a confirmation tone should be heard.
4. Enter the Admin password if the password has been set; a confirmation tone should be heard
indicating that the Station is in Admin Programming mode.
5. Each program is accessed by pressing the
[TRANS/PGM]
button, the following should display:
ENTER PGM NUMBER
6. Dial the desired three-digit program number. If an error is made while entering data, the
[TRANS/PGM]
button will return to the previous status.
NOTE—To return to the previous state while Admin Programming, press the [CONF] button (clears the
temporary data fields).
6.2.2.1 Permanent Update Procedure
To accept changes while programming, perform the following Steps:
1. Press the
[HOLD/SAVE]
button when all changes have been entered to store the data permanently.
2. A confirmation tone should be heard when pressing the
[HOLD/SAVE]
button if all data was
entered correctly. If there were any errors in the entering of data, an error tone will be presented
and data will not be stored in the permanent memory.
6.2.2.2 Resetting the System
To reset the System, perform the following:
1. Enter
[PGM]
+450 then
[FLEX]
+15 and press the
[HOLD/SAVE]
button.
6.2.3 Pre-Programming
6.2.3.1 Location PGM – Nation Code and Site Name (PGM 100)
NOTE—The 4th pole of the DIP switch (SW1) on the MBU must be turned ON.
Nation Code
To program the Nation Code, perform the following Steps:
1. Press the
[TRANS/PGM]
PGM number (100) then
[FLEX1]
+ 7 [Nation Code for CIS].
2. Press the
[HOLD/SAVE]
button to accept the change.
3. Now Rest ARIA SOHO to initialize Database for Nation.
1. Set the 4
th
pole (SW1) of the MBU OFF when the System operates normally, to protect
programmed features.
Site Name
1. Press the
[TRANS/PGM]
Enter Site Name (use the following DKT Map, Max. 24 digits
allowed), then press
[FLEX2]
.
2. Press the
[HOLD/SAVE]
button to accept the change.
