LG-Nortel IP8840, User Manual

IP8840 Broadworks IP Phone 

User 

Guide

 4 

Dec. 

‘08 

3.  Using Features of IP8840 Phone 

3.1.  Receiving a Call 

When you receive a call, your phone rings, the LCD displays the incoming call information and the 

associated line button flashes. 

  To answer a ringing call: 

o

  Lift the handset.  You may press the speakerphone button, line button or the 

Answer

 softkey to 

activate the speakerphone.  To use a headset, press the headset button. 

  To end the call: 

o

  Hang up the handset.  If using the speakerphone, press the speakerphone button.  If using the 

headset, press the headset button. 

  To refuse a ringing call: 

o

 Press 

Refuse

 softkey, the IP Phone stops ringing and the call server routes the call. 

3.2.  Placing a Call 

You place calls with the handset on-hook or off-hook.  Similar to your mobile phone, IP8840 Phone uses 

a technique called ‘store and forward dialing’.  After you dial a digit, the IP Phone waits about 6 seconds 

for additional digits.  If you do not dial additional digits, the IP Phone sends the digits you dialed to the call 

server for processing.  To send the digits immediately, press the # button to indicate dialing is complete, 

and then the IP Phone sends the number to the call server. 

  To place a call: 

o

  Lift the handset.  You may press the speakerphone button or line button to activate the 

speakerphone.  To use a headset, press the headset button. 

o

  Dial the destination number.  After a short delay, the IP Phone sends the number, or dial # to send 

the dialed digits immediately. 

o

  When the called party answers, begin speaking, the LCD displays the elapsed call time. 

  To end the call, 

o

  Hang up the handset.  If using the speakerphone, press the speakerphone button.  If using the 

headset, press the headset button. 

3.3.  Putting a Call on Hold 

You can place a call in a waiting state where the held party cannot hear you and you cannot hear the held 

party.  The held party receives MOH (Music-On-Hold), if configured in the call server. 

While a call is on hold, you can answer or place other calls and can toggle between held calls on the 

same line.  With Call Hold Ringback enabled, the IP Phone rings as a reminder of calls on hold when you 

return the IP Phone to idle.  Refer to your system administrator or Installer Guide for further information. 

  To place a call on hold: