10
ENGLISH
•
When installing on a gypsum board or
medium-density fiberboard (MDF) wall,
fasten the screws to the studs that support
the wall. If there are no studs, check
the distance from the inner wall before
installing.
-
30 mm or below: Install directly on the
inner wall using a 65 mm screw.
-
30 mm or above: Install using a separate
hanger.
Wall
•
When installing the wall mount, check the
positions of the wooden studs using a stud
finder. Then, fasten the screws on at least
two separate studs before proceeding.
Wall mount
Stud
•
When installing the product on wall material
not designated, install the product so that
each location can withstand the pull out
load of 70 kgf (686 N) and shear load of 100
kgf (980 N) or above.
•
Use the Ø 8 mm drill bit for concrete and
hammer (Impact) drill.
Tools you will need
•
Phillips head + driver (manual or
motorized), Ø 3/6/8 mm Drill bit,
Level, Stud finder, Drill
How to attach to masonry
walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm to drill a hole for the
anchor location within a depth of 80 mm
to 100 mm.
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to
the hole. (When inserting the anchor, use
a hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning
to the location of the hole. And, set the
angle adjusting part to face upward.
Wall mount
