10
ENGLISH
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm to drill a hole for the anchor location within a
depth of 80 mm to 100 mm.
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to the hole. (When inserting
the anchor, use a hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning to the location of the
hole. And, set the angle adjusting part to face upward.
Wall mount
5 Align the wall mounting screw to the hole and tighten it. Then,
fasten the screws at torque of 45 kgf/cm to 60 kgf/cm.
Wall mounting screw
•
Make sure that children do not climb on or hang on
the TV.
•
Use a platform or cabinet that is strong and large
enough to support the TV securely.
•
When installing the product, first check that the wall is
strong enough. Use the anchors and screws provided.
-
If you use anchors and screws that are not specified
by the manufacturer, they may not hold the weight
of the product, causing safety issues.
•
Be sure to use the accessory cable provided.
Otherwise, friction between the product and the wall
may cause damage to the connector.
•
When drilling holes into the wall, make sure you use
a drill and drill bit with the specified diameter. Ensure
that you also follow the instructions regarding the
depth of the holes.
-
Otherwise, the product may be installed incorrectly
and cause safety issues.
•
Wear safety gloves when installing the product. Do not
use your bare hands.
-
Otherwise, it may cause personal injury.
•
If some parts of the wall mount do not touch the wall
after it is attached, use the double-sided tape included
in the accessory box to stick the mount to the wall.
•
If you want to connect the TV Cable is connected to
the back panel partition, please use the enclosed
Punching Guide.
