LG SIGNATURE OLED77W9PPA, Safety And Reference

ENGLISH

7

How to attach to masonry walls

Please follow the below direction.

1  Use a drill bit Ø 8 mm to drill a hole for the anchor location within a 

depth of 80 mm to 100 mm.

2  Clean the drilled hole.

3  Insert the sealed wall mounting anchor to the hole. (When inserting 

the anchor, use a hammer.)

Wall mounting anchor

4  Set the wall mount on the wall by aligning to the location of the 

hole. And, set the angle adjusting part to face upward.

Wall mount

5  Align the wall mounting screw to the hole and tighten it. Then, 

fasten the screws at torque of 45 kgf/cm to 60 kgf/cm.

Wall mounting screw 

•  When mounting a TV on the wall, make sure not to 

install the TV by hanging the power and signal cables 
on the back of the TV.

•  Do not install this product on a wall if it could be 

exposed to oil or oil mist. This may damage the 
product and cause it to fall.

•  Make sure that children do not climb on or hang on 

the TV.

•  Use a platform or cabinet that is strong and large 

enough to support the TV securely.

•  When installing the product, first check that the wall is 

strong enough. Use the anchors and screws provided.

-

If you use anchors and screws that are not 
specified by the manufacturer, they may not hold 
the weight of the product, causing safety issues.

•  Be sure to use the accessory cable provided. 

Otherwise, friction between the product and the wall 
may cause damage to the connector.

•  When drilling holes into the wall, make sure you use 

a drill and drill bit with the specified diameter. Ensure 
that you also follow the instructions regarding the 
depth of the holes.

-

Otherwise, the product may be installed 
incorrectly and cause safety issues.

•  Wear safety gloves when installing the product. Do 

not use your bare hands.

-

Otherwise, it may cause personal injury.

•  If some parts of the wall mount do not touch the wall 

after it is attached, use the double-sided tape included 
in the accessory box to stick the mount to the wall.

•  If some parts of the wall mount do not touch the wall 

after using the wall mounting screws for wood, use 
the remaining screws.

•  Be sure to use only the exclusive wall mounting screws 

provided as accessories.

•  If you want to connect the TV Cable is connected to 

the back panel partition, please use the enclosed 
Punching Guide.