13
After Installation
•
When connecting additional cables from the sides, we recommend holding the centre of the TV horizontally or vertically and pulling
the product to make sure there is sufficient distance from the wall before connecting.
•
When connecting additional cables from the bottom, we recommend releasing the TV from the wall mount before connecting.
•
Use cable management systems to arrange the cables at the
bottom of the TV as shown below. Cable managements are not
provided with the product, so purchase them separately.
(For example)
•
After installing the product, be sure to use it adhered to the wall.
-
Using the product while it is not adhered to the wall may damage or shake the product.
•
Do not use a sharp object when you detached the cable cover. This could damage the cable or the cabinet. It may also cause personal
harm.
Antenna/Cable
Connect the TV to a wall antenna socket with an RF cable (75 Ω).
•
Use a signal splitter to use more than 2 TVs.
•
If the image quality is poor, install a signal amplifier properly to improve the image quality.
•
If the image quality is poor with an antenna connected, try to realign the antenna in the correct direction.
•
An antenna cable and converter are not supplied.
•
For a location that is not supported with ULTRA HD broadcasting, this TV cannot receive ULTRA HD broadcasts directly.
Satellite dish
Connect the TV to a satellite dish to a satellite socket with a satellite RF cable (75 Ω). (Depending on model)
