LG 15LT766A, Easy Setup Manual

16

ENGLISH

FCC Radio Frequency Interference 

Requirements (for UNII devices)

(For USA)
High power radars are allocated as primary users of 

the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These 

radar stations can cause interference with and/or 

damage this device. This device cannot be co-located 

with any other transmitter.

FCC RF Radiation Exposure Statement

(For USA)
[For having wireless function (WLAN, Bluetooth,...)]
This equipment complies with FCC radiation exposure 

limits set forth for an uncontrolled environment. This 

transmitter must not be colocated or operating in 

conjunction with any other antenna or transmitter. 

This equipment should be installed and operated with 

minimum distance 20 cm (7.8 inches) between the 

radiator and your body. Users must follow the specific 

operating instructions for satisfying RF exposure 

compliance.

Industry Canada Statement

(For Canada) 
[For having wireless function (WLAN, Bluetooth,...)]
This device contains licence-exempt transmitter(s)/

receiver(s) that comply with Innovation, Science and 

Economic Development Canada’s licence-exempt 

RSS(s). Operation is subject to the following two 

conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including 

interference that may cause undesired operation of 

the device.

IC Radiation Exposure Statement

(For Canada) 
[For having wireless function (WLAN, Bluetooth,...)]
This equipment complies with IC radiation exposure 

limits set forth for an uncontrolled environment. This 

equipment should be installed and operated with 

minimum distance 20 cm (7.8 inches) between the 

antenna & your body.

NOTE

 : THE MANUFACTURER IS NOT RESPONSIBLE 

FOR ANY RADIO OR TV INTERFERENCE CAUSED BY 

UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. 

SUCH MODIFICATIONS COULD VOID THE USER’S 

AUTHORITY TO OPERATE THE EQUIPMENT.

RSS-247 Requirement

(For Canada) 
[For product having the wireless function using 5 GHz 

frequency bands]
(1) The device for operation in the band 5150–5250 

MHz is only for indoor use to reduce the potential for 

harmful interference to co-channel mobile satellite 

systems; 
(2) For devices with detachable antenna(s), the 

maximum antenna gain permitted for devices in the 

bands 5250-5350 MHz and 5470-5725 MHz shall be 

such that the equipment still complies with the e.i.r.p. 

limit;
(3) For devices with detachable antenna(s), the 

maximum antenna gain permitted for devices in 

the band 5725-5850 MHz shall be such that the 

equipment still complies with the e.i.r.p. limits as 

appropriate; and
(4) [For devices operating in the band 5250-5350 

MHz having an e.i.r.p. greater than 200 mW] Antenna 

type(s), antenna models(s), and worst-case tilt 

angle(s) necessary to remain compliant with the e.i.r.p. 

elevation mask requirement set forth in section 6.2.2.3 

of RSS-247 shall be clearly indicated. 

Users should also be advised that high-power radars 

are allocated as primary users (i.e. priority users) of the 

bands 5250-5350 MHz and 5650-5850 MHz and that 

these radars could cause interference and/or damage 

to LE-LAN devices.

NOTE TO CABLE/TV INSTALLER

(For USA and Canada)
This reminder is provided to call the CATV system 

installer’s attention to Article 820-40 of the National 

Electric Code (U.S.A.). The code provides guidelines 

for proper grounding and, in particular, specifies that 

the cable ground shall be connected to the grounding 

system of the building, as close to the point of the 

cable entry as practical.