54
COMMER
CIAL MODE
COMMERCIAL MODE
CLONING CONNECTIONS/TEACHING SETUP
- Connections for the LT2002 to Teach another 20LH1DC1 the Master Setup
Teaching the Master Setup to Another 20LH1DC1
Teach Master 20LH1DC1’s Setup to the target
20LH1DC1
After learning is complete, remove the M.P.I. cable from the
master 20LH1DC1 and connect it to the target 20LH1DC1
that you want to copy the master 20LH1DC1’s setup into.
With “THE CLONE HAS CONTROL OF TV” message
displayed, press 2 to go to the “TEACH TO TV” option,
press ON/OFF, POWER, or ENTER.
Select the LT2002 memory that the new setup is in. Press
On/Off to transfer the new setup and other information to
the new 20LH1DC1. Teaching usually takes 2-3 minutes.
After the “TEACHING COMPLETE” message is displayed,
press any button to return to the Clone menu, then press
ON/OFF, POWER, or ENTER. If finished, detach M.P.I. cable
from the target, newly cloned 20LH1DC1.
Disconnect 20LH1DC1Power for 15 Seconds
Unplug the AC power cord of the newly cloned
20LH1DC1 from the power outlet for about 15 seconds to
activate the newly-copied setup.
Clone Programmer
Master 20LH1DC1
Ferrite Core
(TDK, ZCAT
2035-0930)
Antenna
or CATV
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
- TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
- TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
TEACHING IN PROGRESS,
PLEASE WAIT
TEACHING COMPLETE
This menu should appear after any button is
pressed on the Installer remote.
This display will appear during Teaching
function.
This display will appear after Teaching is
complete.
Summary of Contents for 20LH1DC1
Page 70: ...APPENDIX 70 APPENDIX CLONE TROUBLESHOOTING FLOW CHART ...
Page 71: ...APPENDIX 71 TV OPERATING CHECK ...
Page 74: ...74 NOTE ...
Page 76: ......
