CONNECTIONS
&
SETUP
33
Screen Setup for PC mode
Overview
This function works in the following mode:
Component1, Component2, RGB-PC, RGB-DTV, or HDMI/DVI.
Note: Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust
your monitor’s position, size and phase manually.
Adjustment for screen Position, Clock, Phase
Press the
O
O KK
button and then use
D
D
or
E
E
button to select
PPoossiittiioonn, C
Clloocckk, or PPhhaassee.
Press the
G
G
button and then use
D
D E
E F
F G
G
button to
make appropriate adjustments.
■
The PPhhaassee adjustment range is --3322
~
++3322.
The PPhhaassee only works in Component 1-2, RGB-PC and
RGB-DTV mode.
■
The C
Clloocckk adjustment range is --5500
~
++5500.
The C
Clloocckk only works in RGB-PC mode.
Press the
O
OKK
button.
Initializing (Reset to original factory values)
Press the
O
O KK
button and then use
D
D
or
E
E
button to select
RReesseett.
Press the
G
G
button and then use
F
F
or
G
G
button to select
YYeess.
Press the
O
OKK
button.
To initialize the adjusted values
This function allows you to return to the good picture repro-
duction programmed at the factory and cannot be change.
1
2
3
1
2
3
1
2
3
1
2
3
Position
Clcok
Phase
Reset
G
G
Position
G
G
Clcok
Phase
Reset
PPoossiittiioonn This function is to adjust picture
to left/right and up/down as you
prefer.
C
Clloocckk
This function is to minimize any
vertical bars or stripes visible on
the screen background. And the
horizontal screen size will also
change.
PPhhaassee
This function allows you to
remove any horizontal noise and
clear or sharpen the image of char-
acters. In HDMI/DVI-PC mode,
PHASE is not available.
Initialize Settings
E
E
D
D
F
F
G
G
Close
Close
9U0569A-1 Rev05 1/9/96 2:52 PM Page 33
