78
APPENDIX
APPENDIX
PROGRAMMING THE REMOTE
Programming a code into a remote mode
Test your remote control.
To find out whether your remote control can operate the component without programming, turn on the
component such as a VCR and press the corresponding mode button (such as a D
D V
V D
D or V
V C
C R
R) on the
remote control, while pointing at the component. Test the P
PO
OW
WE
ER
R and P
PR
R +
+//-- buttons to see if the com-
ponent responds properly. If not, the remote requires programming to operate the device.
Turn on the component to be programmed, then press the corresponding mode button (such as a D
D V
V D
D or
V
V C
C R
R) on the remote control. The remote control button of desired device is lighted.
Press the M
ME
EN
NU
U and M
MU
UT
TE
E buttons simultaneously, the remote control is ready to be programmed for the
code.
Enter a code number using the N
NU
UM
MB
BE
ER
R buttons on the remote control. Programming code numbers for
the corresponding component can be found on the following pages. Again, if the code is correct, the device
will turn off.
Press the M
ME
EN
NU
U button to store the code.
Test the remote control functions to see if the component responds properly. If not, repeat from step 2.
The remote is a multi-brand or a universal remote. It can be programmed to operate most remote-control-
lable devices of other manufacturers.
Note that the remote may not control all models of other brands.
1
2
3
4
5
6
Summary of Contents for 42PC1RV Series
Page 2: ......
