- 20 -
2. No Power
(1) Symptom
1) Front LED is NO light.
2) The Set doesn’t discharge little.
(2) Check following
Is plug in power cord?
Plug in power cord.
Yes
No
Is the Line Filter Cable to PSU
connected?
Connect the Cable.
Yes
No
Is the Fuse(F101) on
PSU normal?
Exchange the Fuse.
Yes
No
Is the PSU and Main Board with
13P Cable connected?
Connect a 13p Cable.
Yes
No
After the cable connect is remved
to Power Board(except the EL11
connection cable), the AC voltage
marking is authorized on manual.
When ST-BY 5V is not operated,
replace PSU.
Summary of Contents for 42PC1RV Series
