LG 49UH770T Manual Download

Page: 20 / 44

ENGLISH

• Use a certified cable with the HDMI logo attached.
• If you do not use a certified HDMI

cable, the screen may not display

or a connection error may occur. (Recommended HDMI

Cable Types)

- High-Speed HDMI

Cable (3m or less)

- High-Speed HDMI

Cable with Ethernet (3m or less)

• How to use the ferrite core (Depending on model)

Use the ferrite core to reduce the electromagnetic interference in

the power cord. Wind the power cord on the ferrite core once.

[Wall side]

[TV side]

10 cm (+ / -2 cm)

• Antenna Isolator Installation Guide (Depending on model)

Use this to install TV in a place where there is a voltage

difference between TV Set and GND of antenna signal.

If there is a voltage difference between TV Set and GND of
antenna signal, the antenna contact might be heated and
excessive heat might cause an accident.

You can improve the safety when watching TV by efficiently

removing power voltage from TV antenna. It is recommended
to mount the isolator to the wall. If it cannot be mounted to
the wall, mount it on the TV. Avoid disconnecting the antenna
Isolator after installation.

Before starting, be sure that the TV antenna is connected.

ANTENNA/

CABLE IN

1. Connect to TV.

2. Connect to Set-Top box.

Isolator

Wall

Cable /
Antenna

Connect one end of the isolator to cable/antenna jack and the

other to TV set or set-top box.

“Equipment connected to the protective earthing of the building
installation through the mains connection or through other
equipment with a connection to protective earthing - and to
a cable distribution system using coaxial cable, may in some
circumstances create a fire hazard. Connection to a cable
distribution system has therefore to be provided through a
device providing electrical isolation below a certain frequency
range (galvanic isolator, see EN 60728-11)”

When applying the RF Isolator, a slight loss of signal sensitivity

can occur.

CAUTION

• Do not use any unapproved items to ensure the safety and product

life span.

• Any damage or injuries caused by using unapproved items are not

covered by the manufacturer’s warranty.

• Some models have a thin film attached on to the screen and this

must not be removed.

• When attaching the stand to the TV set, place the screen facing

down on a cushioned table or flat surface to protect the screen
from scratches.

• Make sure that the screws are fastened completely. (If they are

not fastened securely enough, the TV may tilt forward after being
installed.) Do not use too much force and over tighten the screws;
otherwise screw may be damaged and not tighten correctly.

• Make sure to wring any excess water or cleaner from the cloth.
• Do not spray water or cleaner directly onto the TV screen.
• Make sure to spray just enough of water or cleaner onto a dry cloth

to wipe the screen.

• When cleaning the product, be careful not to allow any liquid or

foreign objects to enter the gap between the upper, left or right
side of the panel and the guide panel. (Depending on model)

Separate purchase

Separate purchase items can be changed or modified for quality
improvement without any notification. Contact your dealer to buy these
items. These devices only work with certain models.
The model name or design may be changed depending on the upgrade
of product functions, manufacturer’s circumstances or policies.

(Depending on model)

AG-F***

Cinema 3D Glasses

AN-MR650

Magic Remote

AN-VC550

Smart Camera

AG-F***DP

Dual Play Glasses

AN-TD700

LG Twin TV Engine