LG 50PC1DR - - 50" Plasma TV Training Manual Download

Page: 2 / 138

IMPORTANT SAFETY NOTICE

The information in this training manual is intended for use by individuals possessing an adequate background in
electrical equipment, electronic devices, and mechanical systems. In any attempt to repair a television or monitor,
personal injury and property damage can result. The manufacturer or seller maintains no responsibility for the interpretation
of this information, nor can it assume any liability in connection with its use. When servicing this product, under no
circumstances should the original design be modified or altered without permission from LG Electronics. Unauthorized
modifications will not only void the warranty, but may lead to property damage or user injury. If wires, screws, straps,
clips, nuts, or washers used to complete a ground path are removed for service, they must be returned to their original
position and properly fastened.

CAUTION

To avoid personal injury, disconnect power before servicing this product. If electrical power is required for diagnosis or
test purposes, disconnect the power immediately after performing the necessary checks. Also be warned that many
household appliances present a weight hazard. At least two people should be involved in the installation or servicing of
such devices. Failure to consider the weight of an appliance could lead to physical injury.

ESD NOTICE

Some of the electronics in appliances are electrostatic discharge (ESD) sensitive. ESD can weaken or damage the electronics
in these appliances in a manner that renders them inoperative or reduces the time until their next failure. Connect a
wrist strap to a green ground connection point or unpainted metal in the appliance. Alternatively, you may touch your
finger repeatedly to a green ground connection point or unpainted metal in the appliance. Before removing a replacement
part from its package, touch the anti-static bag to a green connection point or unpainted metal in the appliance. Avoid
unnecessary contact with electronic parts or terminal contacts. Handle the electronic control assembly by its edges only.
When repackaging a failed electronic control assembly in an anti-static bag, observe the above instructions.

REGULATORY INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the
receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected; Consult the dealer or an experienced radio/TV
technician for help.

The responsible party for this device’s compliance is:

LG Electronics of Alabama, Inc.

201 James Record Road

Huntsville, AL 35824, USA

Digital TV Hotline: 1-800-243-0000

Published 2006 by LG Training