115
July 2010 50PJ350 Plasma
Main Board Removing the LVDS Cable or Power Supply Connector
Main Board Removing the LVDS Cable or Power Supply Connector
(1) Using your fingers and press in gently on the two locking ta
(1) Using your fingers and press in gently on the two locking ta
bs.
bs.
Then rock the connector out of the plug.
Then rock the connector out of the plug.
(2) Pull the Cable from the Connector
(2) Pull the Cable from the Connector
by rocking back and forth.
by rocking back and forth.
If the Connector Locks have been
If the Connector Locks have been
damaged and will not release, use a thin
damaged and will not release, use a thin
object and slide straight down (as
object and slide straight down (as
indicated by the arrows below) and
indicated by the arrows below) and
release the locks.
release the locks.
P301 or P703