ENG
ENGLISH
33
MAGIC REMOTE FUNCTIONS
MAGIC REMOTE FUNCTIONS
When the message
Magic remote control battery is low. Change the battery
. is
displayed, replace the battery. To install batteries, open the battery cover, replace
batteries (1.5 V AA) matching
and
ends to the label inside the compartment, and
close the battery cover. Failure to match the correct polarities of the battery may cause
the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. Be
sure to point the remote control at the remote control sensor on the TV. To remove
the batteries, perform the installation actions in reverse.
y
Do not mix old and new batteries, as this may damage the remote control.
CAUTION
This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote sensor.
(POWER)
Turns the TV on or off.
(INPUT)
Changes the input source.
Number buttons
Enters numbers.
(DASH)
Inserts a dash between numbers such as 2-1 and 2-2.
Accesses the saved channel list.
Views the information of the current channels and screen.
Adjusts the volume level.
(MUTE)
Mutes all sounds.
* By pressing and holding the
button, video descriptions function will be enabled.
*
(Secondary Audio Program) Feature can also be enabled by pressing the
key.
(Home)
Accesses the Home menu.
Scrolls through the saved channels.
(BACK)
Returns to the previous screen.
Clears all on-screen displays and returns to TV viewing.
Wheel (OK)
Press the center of the Wheel button to select a menu. You can
change channels by using the Wheel button.
(up/down/left/right) Press the up, down, left or right button to scroll the
menu. If you press
buttons while the pointer is in use, the pointer will
disappear from the screen and Magic Remote will operate like a general remote
control. To display the pointer on the screen again, shake Magic Remote to the left
and right.
(Q. Settings)
Accesses the Quick Settings.
(Screen remote)
Displays the Screen Remote.
* Accesses the Universal Control Menu in some regions.
Used for viewing 3D video.
(Voice recognition)
Network connection is required to use the voice recognition function.
1. Press the voice recognition button.
2. Speak when the voice display window appears on the TV screen.
* Use the Magic Remote no further than 10 cm (4 inches) from your face.
* The voice recognition may fail when you speak too fast or too slowly.
* The recognition rate may vary depending upon the user’s characteristics (voice,
pronunciation, intonation, and speed) and the environment (noise and TV
volume).
Activates or deactivates the subtitles.
Color buttons
These access special functions in some menus. (
Red,
Green,
Yellow,
Blue)
