11
ENGLISH
_inde
x
Registering Magic Remote Control
How to register the Magic Remote Control
To use the Magic Remote, first pair it with your TV.
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
Wheel (OK)
on the remote control.
* If the TV fails to register the Magic Remote, try again after turning the
TV off and back on.
How to deregister the Magic Remote
Control
Press the
(BACK)
and
(HOME)
buttons at the same time, for
five seconds, to unpair the Magic Remote with your TV.
* Press and hold the
button for more than 5 seconds to disconnect
and re-register the Magic Remote at the same time.
•
Do not mix new batteries with old batteries. This may
cause the batteries to overheat and leak.
•
Failure to match the correct polarities of the battery may
cause the battery to burst or leak, resulting in fire, personal
injury, or ambient pollution.
•
This apparatus uses batteries. In your community there
might be regulations that require you to dispose of these
batteries properly due to environmental considerations.
Please contact your local authorities for disposal or
recycling information.
•
Batteries inside or inside the product shall not be exposed
to excessive heat such as sunshine, fire or the like.
•
In Analogue TV and some countries, some remote control
buttons may not work.
User Guide
For more information about this TV, read the USER GUIDE embedded in
the product. (Depending on model)
•
To open the USER GUIDE
→ →
[Support]
→
[User
Guide]
Troubleshooting
Cannot control the TV with the remote control.
•
Check the remote control sensor on the product and try again.
•
Check if there is any obstacle between the product and the remote
control.
•
Check if the batteries are still working and properly installed (
to , to ).
No image display and no sound is produced.
•
Check if the product is turned on.
•
Check if the power cord is connected to a wall outlet.
•
Check if there is a problem in the wall outlet by connecting other
products.
The TV turns off suddenly.
•
Check the power control settings. The power supply may be
interrupted.
•
Check if the auto-off function is activated on the settings related
time.
•
If there is no signal while the TV is on, the TV will turn off
automatically after 15 minutes of inactivity.
When connecting to the PC (HDMI), no signal is detected.
•
Turn the TV off/on using the remote control.
•
Reconnect the HDMI cable.
•
Restart the PC with the TV on.
Abnormal Display
•
If the product feels cold to the touch, there may be a small “flicker”
when it is turned on. This is normal, there is nothing wrong with
product.
•
This panel is an advanced product that contains millions of pixels.
You may see tiny black dots and/or brightly colored dots (red, blue
or green) at a size of 1 ppm on the panel. This does not indicate a
malfunction and does not affect the performance and reliability of
the product. This phenomenon also occurs in third-party products
and is not subject to exchange or refund.
•
You may find different brightness and color of the panel depending
on your viewing position(left/right/top/down).
This phenomenon occurs due to the characteristic of the panel.
It is not related with the product performance, and it is not
malfunction.
•
Displaying a still image for a prolonged period of time may cause
image sticking. Avoid displaying a fixed image on the TV screen for
a long period of time.
Summary of Contents for 75NANO98 Series
Page 17: ...15 ENGLISH _index ...
