31
ENGLISH
19. No Signal Power Off (15 Min) (Command:f g)
Sets the monitor to enter Automatic Standby mode if there is no signal
for 15 minutes.
Transmission
[f][g][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: On
Acknowledgment
[g][ ][Set ID][ ][OK/NG][Data][x]
20. Auto Off (Command: m n)
Sets the monitor to enter Auto Off after 4 hours.
Transmission
[m][n][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: 4 hours
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data][x]
21. Language (Command: f i)
Sets the OSD language.
Transmission
[f][i][ ][Set ID][ ][Data][Cr]
Data
00: Czech
01: Danish
02: German
03: English
04: Spanish (Europe)
05: Greek
06: French
07: Italian
08: Dutch
09: Norwegian
0A: Portuguese
0B: Portuguese (Brazil)
0C: Russian
0D: Finnish
0E: Swedish
0F: Korean
10: Chinese (Mandarin)
11: Japanese
12: Chinese (Cantonese)
Acknowledgment
[i][ ][Set ID][ ][OK/NG][Data][x]
22. Reset (Command: f k)
Performs the reset function.
Transmission
[f][k][ ][Set ID][ ][Data][Cr]
Data
00: Picture Reset
02: Reset to Initial information
Acknowledgment
[k][ ][Set ID][ ][OK/NG][Data][x]
23. Current Temperature (Command: d n)
Checks the current temperature of the product.
Transmission
[d][n][ ][Set ID][ ][Data][Cr]
Data FF: Check status
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data][x]
*The temperature is displayed in hexadecimal values.
24. Key (Command: m c)
Sends a key code for the IR remote control.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data IR_KEY_CODE
Acknowledgment
[c][ ][Set ID][ ][OK/NG][Data][x]
* For key codes, see IR Codes.
25. Time elapsed (Command: d l)
Checks the elapsed time.
Transmission
[d][l][ ][Set ID][ ][Data][Cr]
Data
FF: Read status
Acknowledgment
[l][ ][Set ID][ ][OK/NG][Data][x]
* The data received is shown as a hexadecimal value.
Summary of Contents for 98UH1C
Page 36: ......