OPTIONAL OPERATION
ENGLISH
15
OPTIONAL OPERATION
Installer Setting -Test Run Mode
After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
TEMP
FAN
SPEED
OPER
MODE
When pressing the button and
button simultaneously for more than 3
seconds, the system will be entered into the
installer setting mode.
- After entering into the installer setting
mode, select the test run mode code value
by pressing the button.
* Test run mode code value : 01
1
When pressing the button, the test
operation mode will be performed, and it is
displayed as shown in the left figure.
2
When pressing the button and
button simultaneously for more than 3
seconds after the setting has been
completed, the setting mode will be
released.
- If there isn’t any button input for more than
25 seconds, the installer setting mode will
also be released.
3
When approx. 18 minutes are elapsed after
starting of the test oper-mode, the system
will be stopped automatically and converted
to the standby state.
- If any button is inputted during the test run
mode, the test run mode will be forced to
be relreased.
4
OPER
MODE
OPER
MODE
OPER
MODE
OPER
MODE
What is the test run mode??
- This means the operation of the product under the cooling, strong wind, and Comp on state
without performing room temperature control in order to confirm the installed state during the
product installation.
Summary of Contents for ABNQ18GHLA0
Page 23: ......
