16
REMOTE CONTROLLER INSTALLATION
ENGLISH
- For ceiling type cassette and duct
product group, change the switch setting
of the indoor PCB.
- For wall-mount type and stand type
product, change the master/slave setting
with the wireless remote controller.
(Refer to wireless remote controller
manual for detail)
* When installing 2 remote controllers to
one indoor unit with event
communication function, set the
master/slave of the remote controller.
(Refer to remote controller master/slave
selection)
When controlling the group, some
functions excluding basic operation
setting, fan level Min/Mid/Max, remote
controller lock setting and time setting
may be limited.
Two remote controller
When installing more than 2 wired remote
controllers to one air conditioner, please con-
nect as the right picture.
- When installing more than 2 units of wired
remote controller to one air conditioner, set
one wired remote controller as master and
the others all as slaves, as shown in the right
picture.
- You cannot control the group as shown in
the right for some products.
- Refer to the product manual for more detail.
GND
12V
B
Y R
B
Y R
MASTER
SLAVE
Signal wire
GND
12V
Signal wire
TEMP
FAN
SPEED
OPER
MODE
TEMP
FAN
SPEED
OPER
MODE
- No. 3 Off
- No. 3 On
#3 switch OFF: Master
(Factory default setting)
#3 switch ON: Slave
- When controlling in groups, set the
master/slaver of the remote controller.
Refer to Installer setting section on how to
set master/slave for more detail.
<When simultaneously connecting
2 sets of wired remote controller>
Summary of Contents for ABNQ18GM1A0
Page 26: ......
