ENGLISH
17
OPERATING INSTRUCTIONS
Auto Dry Function
1
Auto dry function can be setted/released
by manipulating indoor unit button or
remote control.
2
When pressing the button after setting
the function, evaporator in indoor unit will
be automatically dried as showing counting
00 to 99 on its display panel .
3
After indicating 99 on the display panel,
the unit will be automatically turned off.
* Auto dry function is released at initial
state as standard.
If manipulating indoor unit, press the
button and button simultaneously for 3
seconds.
If manipulating remote control for Cooling
Only model, press button.
The indoor unit will respond with beep once
and indicate “SC” on its display panel. Then
Auto dry function will be set.
If manipulating indoor unit, press the
button and button simultaneously for 3
seconds.
If manipulating remote control, press
button.
The indoor unit will respond with beep twice
and Auto dry function will be removed.
Auto Restart Operation
When power is supplied again after unit
operation has been stopped because of
interruption of power supply due to outage or
other causes, auto re-operation will be
performed by remembering previous setting.
- When power is supplied, outdoor unit
operation will be started within 3 minutes.
1
Auto Restart Operation can be
established/released by manipulating
indoor unit button.
* When initial state, Auto Restart
Operation will be set up as standard.
Press the , , , (4 buttons)
simultaneously for 3 seconds.
The unit will respond with beep and Restart
Operation will be removed.
After funtion release, Press the , , ,
(4 buttons) simultaneously for 3 seconds.
The unit will respond with beep and restart
operation will be setted.
For Releasing Restart Operation
For Setting Restart Operation
MODE
MODE
For Setting Auto Dry Function
For Releasing Auto Dry Function
MODE
MODE
