![background image](http://html.mh-extra.com/html/lg/arnh763k3b2/arnh763k3b2_installation-manual_213302031.webp)
31
Installation
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
Indirect Water storage tank sensor Well (MeG61846102)
Water Piping
Figure 22: Indirect Water Storage Tank Sensor Well Installation (Typical)
If the storage tank comes with an existing sensor well that can
accommodate the LG provided hot water storage tank sensor,
then skip the first step in the procedure below.
Procedure - Typical
1. Drill and thread a 1/2” FPT hole in the tank wall at the
tank manufacturer’s recommended location.
— This sensor will provide the average tank water tem-
perature to the Hydro Kit.
2. Remove well cap and sensor from the sensor well and
place in a secure location.
3. If welding the well to the tank:
— Insert the well into the thread hole and rotate till the
threads on the neck bottom out. Weld the sensor to
the tank and pressure test as necessary.
4. No welding installation:
— Wrap the threads of the sensor well about 8 times with
Teflon tape. Insert the well into the threaded hole in the
tank wall. Turn clockwise until secure and then finalize
tightening using a socket or open-end wrench.
PT 1/2 inch
Sensor
Holder Cap
Inside Surface of
Domestic Waterside
of Storage
Water Tank Outer Wall
Thermistor
Sensing Bulb
Sensor
Well
Water
Pipe
rouGHING-IN