Connecting
14
C
onnecting
2
Wireless speakers
connection
Setting up the wireless
receiver for the first time
1. Insert the Wireless TX till the marked line into
the WIRELESS connector on the rear of the unit.
Line
2. Connect the power cord of the wireless receiver
to the outlet.
3. When you turn on the main unit, the wireless
speakers connection will be completed
automatically.
-
When the connection is completed, you can
see the yellow-green LED on the wireless
receiver and the indicator ( ) on the main
unit.
LED indicator of wireless receiver
LED Color
Operation
Yellow-green
(Blink)
The wireless receiver is trying to
connect.
Yellow-green
The connection is completed.
Red
The wireless receiver is
in standby mode or the
connection is failed.
Off
(No display)
The power cord of wireless
receiver is disconnected.
y
Do not insert other than the Wireless TX
dedicated for this unit into the WIRELESS
connector. This unit might be damaged or it
may not be removed easily.
y
If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the unit (wireless receiver and main unit)
away from there.
y
It takes a few seconds (and may take longer)
for the Wireless TX and the wireless receiver
to communicate with each other.
y
The available range is 20 m for wireless
connection in an open place.
,
Note
Manually pairing wireless
receiver
When your connection is not completed, you can
see the red LED or the blinking yellow-green LED
on the wireless receiver and the rear speakers are
not made sound. To solve the problem, follow the
below steps.
1. Adjust the volume level of the main unit to
minimum.
-
”VOL MIN” appears on the display window.
2. Press and hold (MUTE) on the remote control
for about 3 seconds.
-
“WL RESET” appears on the display window
briefly.
3. If the LED of the wireless receiver already blinks
in yellow-green continually, you can skip this
step.
Press and hold PAIRING on the rear of the
wireless receiver for more than 5 seconds.
-
The LED of the wireless receiver lights up
alternately in red and yellow-green.
4. Disconnect the power cord of the main unit
and the wireless receiver.
5. Connect them again after the LED of the main
unit and the wireless receiver are fully turned
off.
The main unit and the wireless receiver will
be paired automatically when you turn on the
main unit.
-
When the connection is completed, you can
see the yellow-green LED on the wireless
receiver and the indicator ( ) on the main
unit.
