Installation
24
y
The battery unit must be installed on the floor due to its heavy weight. Wall mounting is
only for supporting purposes.
y
Rotate the legs at the bottom of the battery unit to adjust the level.
y
Install the product on a flat surface.
y
There should be no foreign object that could damage the bottom of the product.
WARNING
c
Hang the enclosure on the wall bracket.
Then, rotate the legs to bring the product level with the floor.
y
Depending on the surface, different screws, anchors and additional supports may be required
for installing the wall brackets. Therefore, these screws and anchors are not provided. The
system installer is responsible for selecting the proper screws and anchors.
y
It is recommended to use stainless steel screws with TX M8 x 50 mm.
INFO
Summary of Contents for BUEL011HBC1
