43
206-4218
Change Tuner
This command enables you to switch to the Tuner Menu for another tuner.
1. At the
Tuner Command >
prompt, type
tuner
and press
Enter
.
2. At the
Enter Tuner number [#]>
prompt, type the number of the OAT100R X-Port
connected to the tuner for which you wish to view/modify configuration. Then, press
Enter
.
The system will identify the (newly) current tuner and then display a command prompt, for
example:
Current Tuner: Tuner-3
Tuner-3 Command >
View Tuner Information
At the
Tuner Command >
prompt, type
info
and press
Enter
to display tuner status and
configuration data, for example:
Tuner-1 Info
=============
Power:
On
Status:
Streaming
Channel:
7
SNR:
32.9
FEC errors:
0
Signal lock: Yes
Bitrate:
19.4
Output:
7
Program selection:
Program 1: 1
Program 2: 2
Program 3: 3
Program 4: NC
Program 5: NC
Program 6: NC
Program 7: NC
Program 8: NC
Under standard operating conditions a powered tuner should be streaming (see also note on
following page). In addition, the tuner should be locked to the antenna signal; the signal-to-noise
ratio should be greater than 18; the number of FEC errors should equal “0” (zero); and the input
bitrates should equal 19.4 Mbps. If a tuner does not appear to be operating normally, refer to
“Receiver Reception” troubleshooting information on page 69.
Configuration Options via Command Line (Cont.)
