46
206-4218
(Continued from previous page)
2. At the
Select input program
prompt, either:
• Press
Enter
to accept the default value in square brackets, or
• Type
0
and press
Enter
to specify “no connection.”
• Type in a new program number and press
Enter
.
After you enter input program 1, the system will prompt for input program 2, then input
program 3, then input program 4, etc.
3. Repeat step 2 to select each of the eight input programs.
Once you specify the last input program, the system will display an overview of the new
program configuration and prompt for confirmation, for example:
New program selection:
Program 1: 2
Program 2: 1
Program 3: 3
Program 4: NC
Program 5: NC
Program 6: NC
Program 7: NC
Program 8: NC
Do you want to save the new configuration? [y/n]:
4. Either:
• Type
y
and press
Enter
to save the new configuration.
• Type
n
and press
Enter
to return to the Tuner Command prompt without changing the
program configuration.
Configure Tuner/Output Assignments
This option enables you to reconfigure tuner/output assignments. Note that each tuner can
only be assigned one output stream. If you remap an existing stream assignment to another
tuner, the initial assignment will be disconnected.
For example: If Tuner 1 is currently streaming on Output 1, and Tuner 2 is remapped so that
it is streaming on Output 1, the initial Tuner 1 assignment will be disconnected. If all tuners
are currently assigned to output streams, Tuner 1 will now be assigned the output that was
previously assigned to Tuner 2. If Tuner 2 initially had “no connection” status before it was
remapped to Output 1, Tuner 1 will now have “no connection” status.
If you wish to remap an existing stream to another tuner, it is recommended that you first
modify the output assignment of the stream in question to “no connection” before you reassign
the stream as required.
Configuration Options via Command Line (Cont.)
(Continued on next page)
