LG CT-29M65VE Service Manual Download

Page: 7 / 29

1. Application Object

These instructions are applied to all of the color TV, MC-049A.

2. Notes

(1) Because this is not a hot chassis, it is not necessary to use

an isolation transformer. However, the use of isolation
transformer will help protect test instrument.

(2) Adjustment must be done in the correct order.But the

adjustment can be changed by consideration of mass
production.

(3) The adjustment must be performed in the circumstance of

25±5°C of temperature and 65±10% of relative humidity if
there is no specific designation.

(4) The input AC voltage of the receiver must keep rating

voltage in adjusting.

(5) The receiver must be operated for about 15 minutes prior

to the adjustment.

3. Focus adjustment

3.1. Preliminary steps

Tune the TV set to receive a digital pattern.
(SVC mode:Automatically mode change the STANDARD
MODE)

3.2. Adjustment Method

1) Single Focus CPT

Adjust the upper Focus volume of FBT for the best focus of
horizontal line A,vertical line B.

2) Double Focus CPT

a) Adjust the lower Focus volume of FBT for the best focus

of vertical line B.

b) Adjust the upper Focus volume of FBT for the best focus

of area A.

c) Repeat above step 1) and 2) for the best overall focus.

4. Purity & Convergence adjustment

4.1. Color purity adjustment

(1) It makes CPT or CABINET enough to demagnetization.
(2) Receive the signal of red raster.
(3) Loosen fixed screw of DY and closely to CPT funnel part.
(4) Check the center of screen that PURITY MAGNET of CPT

by crossing adjustment. At this time, 4 & 6 pole magnet is
located to magnet of nothing.

(5) Move the DY to make equal red on whole screen and it

does not to make the DY by fixed screw after check a
simple color of Red/Green/Blue and white raster whether or
not it is a pollution of color.
(At this time, take care raster of screen and DY must fixing
in the condition which maintains a horizontality.)

(6) Check the TV set by move direction.

4.2. Convergence adjustment

These adjustments can the best condition of focus after
finished purity adjustment.

(1) Receive the signal of cross hatch that BACK RASTER is

black.

(2) Adjust brightness and luminosity till dot appear 9 ~12.
(3) Open angle of the two tab of 4 pole MAGNET by isogonic

angle and accord with vertical line of red and blue color in
the middle of screen.

(4) Maintain as angle of (3) and rotate the tab to accord with

vertical line of Red and Blue color in the middle of screen.

- 7 -

ADJUSTMENT INSTRUCTIONS

Assembling DY to

CPT

CPT Assembling

As preparatory operations before
assembling CPT, wind cotton Tape for
protecting to CPT NECK and DY, CPT
connection parts. At this moment, end
of tape should be over-lapped and
wound in direct route to the NECK.

Let the screen Standard condition.
Operate Heat-Run at least 15
minutes.

Torque is to be 9-11 kg f.cm when
fixing DY.

Fix the Magnet to the position as
shown picture below. Be careful not to
make CPT neck shadow while
adjusting DY.

HEAT RUN

Degaussing

STC Adjustment

PURITY Adjustment

DY Fixing

SCREEN Voltage adj.

W/B Fixing

FOCUS not yet ADJ.

STC not yet ADJ.