A qualified electrician/plumber or competent person should carry out any electrical/
•
plumbing work required to install this appliance.
WARNING
1. This appliance must be supplied with
correct rating voltage and hertz as shown on
instruction manual, and connected to an
individual, properly earthed branch circuit,
protected by a minimum 15 amp circuit
breaker or time delay fuse.
Wiring must be 2 wires with Earth.
2. The power plug must be in a accessible
location adjacent to and not behind the
dishwasher and within 1.2 meters of the
dishwasher side.(See page 9 Fig.A)
3. The power plug must be correctly earthed, if
in doubt, have it checked by a qualified
Electrician. No other appliance should be
connected to the same plug outlet by a
double adapter or similar plug.
Dangerous voltage
To indicate hazards arising
from dangerous voltages.
Note- in case of an application
warning sign, the rules
according to ISO 3864 should
be adhered to.
1. This dishwasher is designed to fit the size
shown as below.
2. Select a location as close to sink as possible
for ease of connection to the water and drain
pipes.
3. To ensure good drainage, the dishwasher
should not be installed more than 3 meters
away from the sink.
4. If dishwasher is installed in a corner, a
minimum of 5cm of space is required
between the washer and an adjacent cabinet
or wall.
7
Unit:mm
INSTALLATION INSTRUCTIONS
For personal safety, remove house
•
fuse or open circuit breaker before
installation.
Do not use an extension cord or
•
adapter plug with this appliance.
Electrical and earthing connections must
comply with the national electrical code/
provincial and municipal code and/or
other local codes.
CAUTION
Any bare wood surrounding the
•
dishwasher should be sealed with a
waterproof paint or sealant to prevent
swelling.
CAUTION
Prepare cupboard opening
Preparation for electrical wiring
