LG D1454 series, Owner'S Manual

10

•  This dishwasher may be fed with either hot or 

cold water. If the water can not be maintained 

below 65ºC, the dishwasher must be connected 

to cold water.

•  When connecting, you may use sealant tape or 

sealing compound to avoid water leaks.

•  Make sure that the line is not kinked or sharply 

bent.

•  It is recommended that the new inlet hose be 

used and not the existing or old hose.

 Final check and assembling

1.  Securely hand tighten supply hose to the 

water supply. 

Plug the power supply cord into an earthed 

electrical point and switch on.

2.    After installing and prior to using the 

dishwasher with crockery, we recommend 

that you use the dishwasher on 

Quick

 mode 

to rinse through. At this stage it is useful to 

ensure that there are no operating problems or 

water leaks. 

When the dishwasher is used for the first 

time, there may be a loud noise, if this 

happens, turn off the power and restart the 

dishwasher.

After installing the dishwasher, you may notice a 

slight sticking of the door to the dishwasher, 

when you open or close the door. If this does 

happen you need to adjust the level of the 

dishwasher.

•  If the door slants to the right, see fig. C and 

follow these instructions:

  1)  Unscrew(counter-clockwise) the left leg of 

the back side and correct the level.

  2)  Check the opening of door and repeat if 

necessary until the door opens and closes 

properly.

•  When the product is correctly leveled, there 

should be no slant, stickiness or friction sound.

Fig. C

Case 1. In case the door is slanted to the right

•  If the door slants to the left, see fig. D and 

follow these instructions:

1)   Check the opening of door if there still 

remains sticky or friction sound.

2)  Check the opening of door and repeat if 

necessary until the door opens and closes 

properly.

•  When the product is correctly leveled, there 

should be no slant, stickiness or friction sound.

Fig. D

Case 2. In case the door is slanted to the left

Water tap

Fig. A

Fig. B

  Connect the water supply hose to the water tap.  

(Fig. A)

  Some models consist of an inlet valve and hose. 

(Fig. B) 

After connecting the inlet hose to the tap, turn on 

the tap to flush out foreign substances (dirt, sand 

or sawdust) in the water lines. Let water drain 

into a bucket, and check the water temperature.  

Connect the supply hose to the water inlet valve. 

INSTALLATION INSTRUCTIONS

 Installation of water inlet hose

 How to level the dishwasher