24
OPERATION
1
Remove the lower rack and remove the cap of
the salt dispenser located on the left side of the
filters.
2
Before using the appliance for the first time, it
is necessary to pour 1 kg of dishwasher salt
and 1 litre of water at the same time if
intending to use the water softener system.
When refilling the salt, use a funnel. Refer to
Before Using
section.
3
Refit the cap tightly.
4
Run the
Rinse
cycle without dishes.
Salt Refill Cycle (1 kg for each load)
• The table describes information of
Auto
programme.
• Cycle may vary on the salt refill amount.
CAUTION
• Do not pour any detergent in the salt dispenser.
It will cause a malfunction.
• Wipe off any spilled salt around the salt
dispenser cap. Saline solution that runs into can
cause corrosion in the tub and to the dishwasher
load.
• Seal the cap properly by aligning it horizontally
and turning it clockwise. A loosely fitted cap may
cause the saline solution to leak from the salt
dispenser into the tub and cause corrosion.
• After refilling the dishwasher salt, a wash
programme should be operated without dishes,
as any spilled salt inside the appliance may cause
rust or damage to the appliance if the left
unwashed.
NOTE
• The salt can be purchased from salt distributors.
Adding Rinse Aid
The
Rinse Aid
indicator appears in the display
when more rinse aid is needed.
The use of rinse aid is recommended to prevent
water spots on dishes and to enhance drying
results.
1
Open the rinse aid lid by lifting up the flap.
2
Add a liquid rinse aid to the maximum fill level.
The rinse aid should be settled in the dispenser
while filling, or air bubbles may result in poor
drying results.
H1
H2
H3
H4
Cycles
130
50
20
10
Salt
Wa
ter
