ENGLISH
BEFORE CALLING FOR SERVICE
(cont.)
Problem
Possible Causes
Solutions
Steam doesn’t
generate but no error
code is shown
• Water level error.
• Unplug dryer and call for service.
Garments still
wrinkled after
Steam FreSh
™
• Too many or too different
types of garments in dryer.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
there are no creases
left on garment after
Steam FreSh
™
• The function of this cycle
is to remove wrinkles from
fabric.
• Use an iron to make creases.
Garments have
static after reDUCe
StatIC
• This is normal.
• Depends on individual moisture level in skin.
Garments are too
damp or too dry after
reDUCe StatIC
• Correct drying options not
selected.
• Select load weight manually before starting
REDUCE STATIC option.
Garments are not
uniformly damp after
eaSY IrON
• Number of garments or load
size not properly selected at
the beginning of the cycle.
• Select the correct number or garments or load
size before starting the cycle.
Water drips from door
during Steam Cycle
• This is normal.
• Condensation will normally form on the inside
of the dryer door during steam operation. Some
condensation may drip out the bottom of the door.
Steam is not visible
during Steam Cycle
• This is normal.
• Steam vapor is difficult to see when the door is
closed. However, condensation will normally form
on the inside of the dryer door if the steam system
is operating normally.
Drum does not turn
during Steam Cycle
• This is normal.
• The drum is turned off so that the steam vapor
remains in the drum. The drum will normally turn
for about 2 seconds once a minute.
Cannot see steam
vapor at the
beginning of cycle
• This is normal.
• Steam is released at different stages of the cycle
for each option.
• MORE TIME button pressed.
Odors remain in
clothing after
Steam FreSh
™
• STEAM FRESH
™
did not
remove odor completely.
• Fabrics containing strong odors should be
washed in a normal cycle.
• This display indicates that the steam option has
been set for a “ ” item such as a comforter.
Press the LESS TIME button to reduce the
indicated load size.
FLOW SeNSe
indicator light is on
during the drying
cycle
• Ductwork is too long or has
too many turns/restrictions.
• Significant blockage of the
ductwork due to lint buildup
or debris.
• The appliance has detected
a restriction in the external
dryer venting.
• Install a shorter or straighter duct run. See the
Installation Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times
may be longer.
• If exhaust restrictions are sensed by the FLOW
SENSE system, the indicator will remain on for two
hours after the end of the cycle. Opening the door or
pressing the POWER button will turn off the display.
CheCK FILter light
is on during the
drying cycle
• Lint filter is almost clogged
or full.
• Pause the drying cycle and clean the lint filter.
the display shows
41
