37
Reference
Troubleshooting
Symptom
No power.
No picture on the LCD
or TV (including video
from another unit).
No sound.
The DVD player does
not start playback.
No response when but-
tons are pressed.
The remote control does
not work properly.
Correction
• Plug the power cord into the wall outlet securely.
• Recharge the battery.
• Connect the video cable into the jacks securely.
• Set the A/V IN/OUT switch correctly.
- While you are playing a disc, set the A/V IN/OUT
switch to OUT mode
- While you are viewing video from other equipment,
set the A/V IN/OUT switch to In mode.
• Select a LCD mode other than OFF.
• Adjust the brightness.
• Select the appropriate video input mode on the TV
so the picture from the DVD player appears on the
screen.
• Select the correct input mode of the audio receiver
so you can listen to the sound from the DVD player.
• Connect the audio cable into the jacks securely.
• Insert a playable disc. (Check the disc type, color
system and Regional code.)
• Cancel the Rating function or change the rating level.
• “
” may appear on the screen during operation.
• Operate the remote control within about 23 ft (7 m).
Cause
• The power cord is disconnected.
• The battery is discharged.
• The video cable is not connected securely.
• The A/V IN/OUT switch is not set correctly.
• LCD mode is set to OFF.
• Check that Brightness control is set to “–”.
• The TV is not set to receive DVD signal
output.
• The equipment connected with the audio cable
is not set to receive DVD signal output.
• The audio cables are not connected
securely.
• An unplayable disc is inserted.
• The Rating level is set.
• Some discs prohibit certain operations.
• The remote control is too far from the
DVD player.