7
Hooking up the unit
Audio and Video Connection
Connect the AV OUT jack on the unit to the corresponding input jacks on your
TV using the supplied AV cable as shown below.
Note
: The signal does not come out from AV OUT jack when the unit is set to
[TV]
mode.
Revolving the LCD panel
You can revolve the LCD panel of the unit clockwise a maximum of 180
degrees for use. You can also operate the unit after revolving the LCD panel
180 degrees and folding it back down.
To revolve the LCD panel, place the unit on a stable and even surface such
as on a table. Push the LCD panel up and then lift it into a vertical position.
Revolve the LCD panel clockwise slowly 180 degrees. If you need, fold the
LCD panel after revolving it.
To revolve the LCD panel to its original position, open the LCD panel to a
vertical position. Revolve the LCD panel counter clockwise slowly 180 degrees.
• When finished using the unit, return the LCD panel to its original position.
• Do not leave the LCD panel in the face-up position, or sudden shocks may
damage it.
Selecting the operation mode
You need to select a operation mode before
using this unit. Press
MODE
on the unit and the
operation mode selection menu appears. Use
b / B
to select a mode then press
ENTER
.
• Select [DISC] to playback the inserted disc.
• Select [TV] to view the TV connecting the antenna.
• Select [USB] to playback the file(s) in the connected USB Flash Drive.
Right side of the unit
Plug into the
“AV OUT” jack.
TV
Manufactured under license from Dolby Laboratories. “Dolby” and the
double-D symbol are trademarks of Dolby Laboratories.