16
OPERATION
OPERATION
Operation Overview
Using the Appliance
Before the first cycle, set the appliance to dry for 5
minutes to warm up the drum. Open the door
between loads the first few times you use the
appliance to allow any odours from the interior of
the appliance to disperse.
Children must be supervised so that they do not
climb inside the drum.
1
Ensure the lint filter and water collection tank
are clean.
• Open the door and ensure the lint filter is
clean. When the filter is full with lint, drying
times will be longer than usual.
• Pull out the water collection tank and empty
the condensed water. When the water
collection tank is full, the appliance may stop
during the cycle.
NOTE
• In some instance, LED window may display
E
icon to inform you that the water collection tank
is full. If this occurs, empty the water collection
tank.
2
Place the clothes into the drum after sorting
and close the door.
• Push the clothes deep into the drum so that
the clothes keeps away from the door seal.
When the clothes get stuck between the
door and seal, they may get damaged while
drying.
• The clothes should be sorted by fabric types
and dryness level.
• All strings and attached belts of clothes
should be well tied and fixed before being
put into the drum.
3
Press the
Power
button to turn the appliance
on.
• Depending on the models, the
Power
button
may light up to indicate that the appliance is
ready for dry.
4
Choose a drying programme by turning the
programme selector knob.
• If you press the
Start/Pause
button without
choosing a programme, the appliance will
proceed with the
Cotton
programme.
Please refer to the programme table for the
detailed information.
5
Press the
Start/Pause
button to start the
drying programme.
6
After the drying programme has finished, open
the door and unload the clothes.