11
EN
•
If possible, install the appliance in one of the
corners of the room, where the floor is more
stable.
•
Fit the rubber cups to reduce vibration.
NOTE
•
You can purchase rubber cups (Part
No.4620ER4002B) from the LG Electronics
service centre.
Ventilation
•
Make sure that air circulation around the
appliance should not be impeded by carpets,
rugs, etc.
Ambient Temperature
•
Do not install the appliance in rooms where
freezing temperatures may occur. Frozen hoses
may burst under pressure. The reliability of
the electronic control unit may be impaired at
temperatures below freezing point.
•
If the appliance is delivered in winter and
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
Electrical Connection
•
Do not use an extension cord or double adapter.
•
Always unplug the appliance and turn off the
water inlet after use.
•
Connect the appliance to an earthed socket in
accordance with current wiring regulations.
•
The appliance must be positioned so that the
plug is easily accessible.
•
Repairs to the appliance must only be carried
out by the qualified personnel. Repairs carried
out by inexperienced persons may cause injury
or serious malfunctioning. Contact your LG
Electronics service centre.
•
Power outlet must be at least 1 meter of either
side of the location of the appliance.
WARNING
•
The power plug must be plugged into an
appropriate socket outlet that is installed and
grounded in accordance with all local codes and
ordinances.
Unpacking the Appliance
Lifting the Appliance Off the Foam
Base
* This feature may vary depending on the model
purchased.
1
After removing the carton and shipping
material, lift the appliance off the foam base.
Make sure the tub support
a
* comes off with
the base and is not stuck to the bottom of the
appliance.
2
If you must lay the appliance down to remove
the carton base
b
, always protect the side of
the appliance and lay it carefully on its side. Do
not lay the appliance on its front or back.
*